NEC Express5800/110Ei, User Manual

Page: 84 / 314

4-22 Configuring Your Server
See the table below for the items.
Option Parameter Description Your Setting
User Password Is Clear
Set Status only, user cannot modify.
Once set, this can be disabled by
setting it to a null string, or by clearing
password jumper on system board
(see Configuring Mother Board
Jumpers in this Chapter).
Supervisor
Password Is Clear
Set Status only, user cannot modify.
Once set, this can be disabled by
setting it to a null string, or by clearing
password jumper on system board
(see Configuring Mother Board
Jumpers in this Chapter).
Set User
Password Up to eight
alphanumerics Supervisor password controls access
to the setup utility.
When
Enter is pressed, the user is
prompted for a password; press Esc
to abort. Once set, this can be
disabled by setting it to a null string, or
by clearing password jumper on
system board (refer to Configuring
Mother Board Jumpers in this
chapter).
Set Supervisor
Password Up to eight
alphanumerics When the <Enter> key is pressed, the
user is prompted for a password;
press ESC key to abort. Once set, this
can be disabled by setting it to a null
string, or by clearing password jumper
on system board (refer to Configuring
Mother Board Jumpers in this
chapter).
Password on boot [Disabled]
Enabled
Disables or enables password entry
on boot.
Fixed disk boot
sector [Normal]
Write Protect Will write protect the boot sector of the
hard drive to prevent viruses from
corrupting the drive under DOS if set
to write protect.
Diskette access User
[Supervisor] Controls access to the floppy disk
drive.
[ ]: Factory-set