NEC Express 5800/320Lc, User Manual

Page: 352 / 365

8-42 System Upgrade
1.
Mount the N8804-001P1 100BASE-TX adapter to the slot with the same number in PCI
module #1 and #2, and then start Windows Server 2003, Enterprise Edition.
After starting Windows Server 2003, Enterprise Edition, the drivers are installed
automatically.
IMPORTANT:
If the [Digital Signature Not Found] dialog box appears, click the [Yes]
button.
2.
Build a dual LAN configuration. (See "Setting Dual LAN Configuration" in the separate
volume “User’s Guide (Setup).”)
IMPORTANT:
You can also select [Load Balancing] in step 3 in "Setting Dual LAN Configuration". In
this case, [Team #1:Adaptive Load Balancing Mode] is added to Network Component
Tree.
Moreover, select [Stratus AA-U51500 10/100 Enet Adapter] instead of [Stratus
emb-82559 10/100 Enet Adapter] in Steps 4 and 5.
If you build a dual configuration by using two pairs of adapters in Step 5, add an
adapter in the same way.
PCI Board Status LED Indications
LED
indications
Description Action
Amber Duplex is specified, however,
the server works in simplex
mode. Specify duplex (AFT, ALB).
Specify an appropriate driver.
PCI board is properly installed
and operates in non-duplex
mode (AFT, ALB). (Does not
depend on simplex or duplex.) In non-duplex mode, no special problem
occurs.
PCI board is installed to operate
in the duplex mode. The system is operating normally in duplex
mode.
Off
The PCI board is not installed
yet, the PCI board is installed
incorrectly, or the power is not
supplied. Mount the PCI board correctly.
If the PCI board was not mounted, there is no
problem.
Check the condition of power unit.
Remount the PCI module.
In the process of configuring or
canceling the duplex mode. Wait for a while until the indication changes. If
the indication unchanged, check the PCI board
slot status using NEC ESMPRO Manager. Red
Although the PCI board is
mounted, it may be offline or not
be working. Make the slot of the board installed from NEC
ESMPRO Manager online.
Mount the PCI board correctly.