NEC EcoPowerGateway N8142-36F, User Manual

Page: 111 / 136

Troubleshooting 6-5
On-screen error message Recommended action
0252 Password checksum bad -
Passwords cleared The password has been cleared.
1. Run the BIOS SETUP utility to correct the setting.
2. If the same error persists, contact your service
representative.
0260 System timer error
0270 Real time clock error
1. Take one of the following measures to power off the
maintenance card and then on.
* Press the Maintenance switch to power off the
maintenance card, then press it again to power on.
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC ESMPRO
Manager.
2. If the same error persists, contact your service
representative.
0271 Check date and time
Settings 1. Run the BIOS SETUP utility to set the current date and
time.
2. If the same error persists, contact your service
representative.
02D0 1. Take one of the following measures to reboot (reset)
the maintenance card.
* Press
Ctrl + Alt + Del .
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC ESMPRO
Manager.
2. Take one of the following measures to power off the
maintenance card and then on.
* Press the Maintenance switch to power off the
maintenance card, then press it again to power on.
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC ESMPRO
Manager.
3. If the same error persists, contact your service
representative.
0B70 The error occurred
during temperature
sensor reading 1. Take one of the following measures to reboot (reset)
the maintenance card.
* Press
Ctrl + Alt + Del .
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC ESMPRO
Manager.
2. Take one of the following measures to power off the
maintenance card and then on.
* Press the Maintenance switch to power off the
maintenance card, then press it again to power on.
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC ESMPRO
Manager.
3. If the same error persists, contact your service
representative.