Nautel NX5 AM, Operation & Maintenance Manual

Page: 154 / 220

NX5 OPERATION & MAINTENANCE MANUAL OPERATING THE TRANSMITTER
PAGE 3.2.134 VERSION 0.1 2015-08-01
System Settings - Front Panel UI
You can establish various user settings for the NX5 using the local front panel UI’s Main Menu ->
System Settings menu (see Figure 3.2.114 ).
Figure 3.2.115: System Settings Menu
The following options are available:
 Host Reset: see Host Reset, on page 3.2.135 ***
 Host Watchdog: see Configuring Host Watchdog, on page 3.2.136
 Console Select: see NOTE in Figure 3.2.114
 OS Recovery: see OS Recovery, on page 3.2.136
 Firmware Update: see Updating Firmware, on page 3.2.137 ***
 LCD Settings: see Adjusting LCD Display Settings, on page 3.2.138
 Run TCXO Cal: see Run TCXO Calibration, on page 3.2.139 ***
 Exciter Sync: see Exciter Synchronization, on page 3.2.140
 RF Monitor: see RF Monitor Settings, on page 3.2.142 ***
 Power Lockout: see Power Lockout Settings, on page 3.2.143 ***
 Power Thresholds: see Power Threshold Settings, on page 3.2.145 ***
 PM Inhibit: see PM Inhibit, on page 3.2.146
*** NOTE
: The remote AUI also has a
System Settings
menu, which contains similar functions to the
front panel UI (e.g., host reset, firmware update, RF monitor level, etc.). In this case, refer to System
Settings - Remote AUI, on page 3.2.127 for information on the front panel UI settings. Additional user
settings, available only through the front panel UI, are described in this section.
NOTE:
Changing selections in the Console Select
menu is not normally required and should only
be performed by trained personnel. Information
on this sub-menu is not included in the manual.
If necessary, contact Nautel for assistance