Matsushita Electric Works Fire & Security Technology AB
MEW00442
Rev: -
Operating Instructions EBL512, V1.44.x
66
24.6
Re-enable control output (H2/B6)
Disabled outputs are listed in menu H4/U1. From this menu, it's also
possible to get a print-out.
When all control outputs have been re-enabled, The LED "Disabled"
will be turned OFF, if there are no other disablements in the system.
Action
Text in display
Comments
"Access"
According to chapter
"Access", see page 57.
Scroll to menu H2.
Disable or re-enable
ACCEPT? H2
"A"
Disable zone
ACCEPT? B1
Scroll to menu B6.
Re-enable control output
ACCEPT? B6
"A"
Re-enable control output type: 0
0=RU/SU 1=S 2=R 3=RE 4=ES ACCEPT?
(4=ES not shown in Swedish (RUS)
convention)
Push:
"0"=RU4 (2265) or
SU4 (2262 / 2263),
"1"=S0-S3,
"2"=R0-R1 or
"3"=Relay board 1581
"4"=1583 board output
"Extinguishing system".
Push "A" to accept.
"A"
Depending on the
chosen type, 0, 1, 2, 3
resp. 4, the following
will be shown:
Re-enable 00 0000 output 0
ACCEPT? L
Re-enable control unit 00 S0
ACCEPT? L
Re-enable control unit 00 R0
ACCEPT? L
Re-enable control unit 00 relay board 0
output 0 ACCEPT? L
Re-enable output for extinguishing
system on 1583 board, CU 00 ACCEPT? L
If there are no outputs to
re-enable, menu B6 will be
shown again.
If it's the correct output to
re-enable, push "A" to
accept. If not, scroll or
write the wanted output
and push "A" to accept.
"A"
Re-enable control output type: 0
0=RU/SU 1=S 2=R 3=RE 4=ES ACCEPT?
If more re-enablements
shall be done, continue like
above. If not, push
"Return" to menu B6.
Scroll or push "Return" to
menu H2. Scroll or push
"Return" to logout.
