Mountz SDC-24, Operation Manual

Page: 5 / 94

47) Converted Torque Display for Real Time Monitoring P128 48
48) Error History (Except the Pattern Error)
P200~207
48
49) Torque Tuning
P211~218
49
50) Others 49
7.7 Error code
50
7.8 Preset Number Selecting by Sensor
52
7.9 Wiring Example of Check Out Signal Output
53
7.10 Preset # Selecting by 25P I/O Port 54
7.11 25Pin I/O Port Configuration 54
7.11.1 25Pin I/O Configuration (I) - for Sensor
55
7.11.2 25P I/O configuration (II) - for PLC
56
7.11.3 25P I/O configuration (III) - for PLC
57
7.11.4 25P Interface – Input 58
7.11.5 25P Interface - Output 59
7.11.6 Wiring of the Alarm signal to the Tower Lamp
60
7.11.7 Error code pin composition on 25P Output
60
7.12 25PIN I/O Timing Chart
61
7.13 Built in Screw Counter 62
7.13.1 Fastening Quality Verification (OK/NG) 62
1) Fastening OK
62
2) Fastening NG 63
3) Fastening NG - No Torque Up 63
7.13.2 Count Start & Stop Signal to SDC 64
7.13.3 Wiring of Count Start & Stop 68
7.13.4 Operation of Screw Counter on SDC 70
7.13.5 FND Display for Counter Mode
71
7.13.6 FND Display for Model Selecting
71
1080 N 11th St - San Jose CA 95112 - mountztorque.com 5