Mountz SDC-24, Operation Manual

Page: 57 / 94

7.11.3 25P I/O Configuration (III) – for PLC
Torque selector by Sensor (Input) + PLC (Output)
[ P20 Setting ] - " 2 " : Combined
PIN no. Configuration IN / OUT
1 Torque select IN1
INPUT
(to Controller)
2 Torque select IN2
3 Torque select IN3
4 Torque select IN4
5 Torque select IN5
6 Torque select IN6
7 Torque select IN7
8 Torque select IN8
9
Reset ( include cycle reset )
or Work-piece move OUT from area
(P80 "3" selected )
19 Work-piece move IN to area
23 Model select IN1
24 Model select IN2
10 Error code OUT1
OUTPUT
(to Controller)
11 Error code OUT2
12 Error code OUT3
13 Error code OUT4
14 Status of F/R OUT (F:0, R:1)
15 Torque up ( without verifying result )
16 Status of Motor Run OUT
17 READY
18 ALARM (NG)
20 Cycle count complete
25
Fastening OK OUT (verifying
OK) 21 Output COM 22 Input
COM
1080 N 11th St - San Jose CA 95112 - mountztorque.com 57