PREPARATION BEFORE STARTING MASS PRODUCTION E-21
18)
Operate the chuck to clamp a workpiece.
•
•
19)
Close the front door.
Make sure that you can press the EMERGENCY
STOP button or the
(STOP) switch
immediately if an abnormality occurs.
20)
Check the tool motion on the PROGRAM screen by
pressing the
(START) and
(STOP)
switches alternately.
Check the interference between the tool and the
workpiece or the chuck.
1.
The program stops at each block since the
single block function is valid.
However, press the
(STOP) switch if
the X- or Z-axis starts moving.
2.
If the coolant OFF mode is currently valid,
coolant will not be supplied even if an M08
(coolant ON) command in the program is
carried out.
21)
Check the clearance between the cutting tool and
the chuck in comparison with the data for "DIST. TO
GO" which is displayed on the screen.
If there is a possibility of interference between the
tool and the chuck, stop no-load running and
correct the program. Then, check the program
again.
22)
After the completion of the first axis movement
block, select any of the following modes with the
mode selection switch.
(H)
(JOG)
(RPD)
(ZRN)
The spindle stops rotating when any of these modes
is selected.
23)
With the manual door type machine, press the
DOOR UNLOCK switch
to unlock the front
door. Then open the front door.
With the automatic door type machine, open the
front door by pressing the AUTOMATIC DOOR
OPEN switch.
NOTE
CYCLE
START
STOP
NOTE
NOTE
MEM
MDI
TAPE
EDIT
H
JOG
RPD
ZRN
DOOR
UNLOCK
NOTE
