MANUAL OPERATION B-77
Adjust the clearance between the work rest and the workpiece so that the center comes
into the center hole range indicated by the arrow A in the illustration below. If the
clearance is too small, the work rest may interfere with the workpiece.
If the center moves out of the range indicated by the arrow A, there is a danger that it will
interfere with the workpiece end face the next time an attempt is made to hold a
workpiece.
5)
Adjust the tailstock-side work rest position.
a)
Z -, and X- axis direction: Adjust the position by handle feed operation.
b)
Y-axis direction:
Adjust the position by loosening the screws for adjustment
in the X-/Y-/Z- direction on the tailstock-side work rest.
Provide a little clearance so that the center comes into the center hole range by using the
same procedure as in step 4).
Work rest
Workpiece
Clearance
Workpiece
Center hole
Center
Spindle
Tailstock spindle
A
NOTE
Screws for adjustment in the Y-axis direction
