E-2 PREPARATION BEFORE STARTING MASS PRODUCTION
19.
The work counter is not in the counted up state (work counter specification).
20.
If the rotary tool spindle is rotating, the spindle speed arrived signal has been turned on (M
type).
21.
Restart of rotary tool spindle rotation is not valid when the automatic operation is temporarily
suspended (M type).
22.
The bar stock in the bar feeder is not used up (bar feeder specification).
23.
The start interlock is disabled.
*2
*1
Condition that spindle has stopped by having switched the machine operation mode
from automatic to manual. (Reset is not completed)
*2
When the machine is reset during automatic operation in the memory mode
(including feed hold state), the start interlock becomes enabled. This interlock
function prevents restarting of automatic operation with modal information such as
offset data being canceled that may lead to interference between the tool and the
workpiece. If an attempt is made to run a program in the memory mode with the
start interlock function enabled, the message "EX5004 CHECK PROGRAM START
POSITION" is displayed and the automatic operation will not start. To reset the start
interlock function, perform any of the following operations.
•
Program number search (including work No. search from external devices)
•
Operation mode change
When the operation mode is changed from the memory mode to another mode or
when the program edit mode is selected, the start interlock function is disabled.
NOTE
