Mitsubishi MELSEC iQ-F, User Manual

Page: 78 / 182

76
6 WIRING
6.1 Spring Clamp Terminal Block
6
WIRING
This section explains the multiple input module wiring.
6.1
Spring Clamp Terminal Block
Suitable wiring
The wires to connect the spring clamp terminal block are described below.
Wire end treatment
Strip the cable about 10 mm from the tip to connect a wire ferrule at the striped area. Failure to do so may result in electric
shock or short circuit between adjacent terminals because the conductive part. If the wire strip length is too short, it may result
in the poor contact to the spring clamp terminal part.
Depending on the thickness of the sheath, it may be difficult to insert into the insulation sleeve, so select the wires by referring
to the appearance diagram.
The following table shows wire ferrules and tools for wire ferrules compatible with the terminal block. Use of items other than
these may result in not being able to remove the wire ferrule, so carefully check that the wire ferrule can be unplugged.
<Reference product>
No. of wire per terminal Wire size
Single wire, Strand wire Ferrule with insulation sleeve
Single wiring AWG24 to 16
(0.2 to 1.5 mm
2
)
AWG23 to 19
(0.25 to 0.75 mm
2
)
Strand wire/single wire Ferrule with insulation sleeve
Manufacturer Model Wire size Crimp tool
PHOENIX CONTACT GmbH & Co. KG AI 0.5-10 WH 0.5 mm
2
CRIMPFOX 6
AI 0.75-10 GY 0.75 mm
2
AI 1.0-10 1.0 mm
2
AI 1.5-10 1.5 mm
2
10 mm 10 mm
Contact area
(Crimp area)
16 to 18 mm
2 to 2.8 mm
Insulation sleeve