Mitsubishi MOTORS Outlander PHEV 2017, Owner'S Manual

Page: 65 / 548

Symptom Possible cause Possible solution
A charging cable for other vehicle
is used. Use the EV charging cable only for your vehicle.
A normal charger which does not
correspond to your vehicles is
used. Consult an administrator or a maker of the normal charger that it corresponds to
your vehicle. Also perform normal charging according to the operating procedure
indicated on the body of normal charger.
The reservation of Charging timer
is set up by MITSUBISHI Remote
Control (if so equipped) or by the
MITSUBISHI Multi-Communica-
tion System (MMCS) (if so equip-
ped). The normal charging cannot be started when the charging cable is connected, if the
charging timer is set. Cancel all the charging timer settings, if you want to start the
normal charging immediately.
Refer to “MITSUBISHI Remote Control” on page 3-24.
For the MITSUBISHI Multi-Communication System (MMCS) refer to the separate
owner’s manuals.
Normal charging is dis-
continued.
There is no power coming from
the outlet. There may have been a electrical power failure, or the breaker may have failed.
Charging will resume when the power source is reset.
The EV charging cable has been
disconnected. Check that the EV charging cable has not been disconnected.
The button on the normal charge
connector has been pressed. If the charge connector button is pressed for a long period of time, charging will be
stopped. Start the charging procedure again.
The temperature of the drive bat-
tery is too high or too low to
charge. Confirm the drive battery temperature.
Refer to “Cautions and actions to deal with intense heat” on page 2-11 and “Cau-
tions and actions to deal with intense cold” on page 2-11.
Charging is stopped by the normal
charge timer. Charging will stop depending on the timer function setting of the normal charge
device. Try it again with cancelling the timer settings.
Charging troubleshooting guide
3-22
OGGE17E1
Charging
3