Mitsubishi MOTORS Outlander PHEV 2017, Owner'S Manual

Page: 206 / 548

[When the sensor is malfunctioning]
NOTE
l If the sensor or its surrounding area reaches
an extremely high temperature when parking
the vehicle under a blazing sun, the “AHB
SERVICE REQUIRED” warning display
may appear.
If the warning display remains even after the
temperature of the sensor or its surrounding
area has been in range, please contact a
MITSUBISHI MOTORS Authorized Serv-
ice Point.
Sensor is too hot or cold
If the system becomes temporarily unavaila-
ble due to a high or low temperature of the
sensor, the following warning display will
appear.
After the temperature of the sensor has been
in range, the system will automatically return
to operation.
If the warning display does not disappear af-
ter waiting for a while, there is a possibility
that the automatic high-beam system has a
malfunction. Contact a MITSUBISHI
MOTORS Authorized Service Point for in-
spection of the system.
Windscreen is dirty
If the automatic high-beam system deter-
mines that its performance has been degra-
ded, the warning display will appear.
This can occur when:
l Foreign objects, such as dirt, snow or
ice, adhere to the windscreen of the sen-
sor portion.
l
There are adverse weather conditions,
such as rain, snow, sand storms, etc.
l A vehicle in front or an oncoming vehi-
cle is splashing water, snow or dirt.
When the sensor performance returns, the au-
tomatic high-beam system will resume opera-
tion.
If the warning display does not disappear af-
ter waiting for a while, there is a possibility
that the sensor has a malfunction. Contact a
MITSUBISHI MOTORS Authorized Service
Point for inspection of the sensor.
Welcome light
E00528902072
This function turns on the position and tail
lamps for about 30 seconds after the UN-
LOCK switch on the remote control transmit-
ter is pressed when the combination head-
lamps and dipper switch is in the “OFF” or
“AUTO” position. The welcome light func-
tion will operate only when it is dark outside
the vehicle.
NOTE
l While the welcome light function is operat-
ing, perform one of the following operations
to cancel the function.
• Push the LOCK switch on the remote
control transmitter.
• Turn the combination headlamps and dip-
per switch to the “
” or “ ” position.
Combination headlamps and dipper switch
6-59
OGGE17E1
Instruments and controls
6