Mitsubishi MOTORS Outlander PHEV 2017, Owner'S Manual

Page: 442 / 548

CAUTION
l Be careful not to get your fingers trapped be-
tween the tyre and wheel as the tyre inflates.
l The surface of the compressor will get hot
while the compressor is running. Do not
keep the compressor running continuously
for more than 10 minutes. After using the
compressor, wait for the compressor to cool
before using it again.
l If the compressor becomes sluggish or hot
while operating, it is overheating. Immedi-
ately place the switch in the OFF position
and let the compressor cool down for at least
30 minutes.
NOTE
l If the tyre pressure does not rise to the speci-
fied level within 10 minutes, the tyre may be
so severely damaged that the tyre sealant
cannot be used to effect an emergency re-
pair. Please contact a MITSUBISHI
MOTORS Authorized Service Point or an-
other specialist in this event.
16. Turn OFF the compressor switch, then
pull the power cord plug out of the sock-
et.
NOTE
l Simply putting sealant and air into the tyre
using the tyre repair kit does not seal the
puncture hole. Air will leak through the
puncture hole until the emergency repair
procedure is completed (through step 19 or
step 20 of these instructions).
17. Affix the speed restriction sticker (Q) to
the three-diamond mark on the steering
wheel.
CAUTION
l Do not affix the sticker anywhere except the
specified position on the pad of the steering
wheel. Affixing the sticker in an incorrect
position could prevent the SRS airbag from
working normally.
18. When you have inflated the tyre to the
specified pressure, stow the compressor,
bottle, and other items in the vehicle and
promptly start driving the vehicle so that
the tyre sealant can spread evenly in the
tyre. Drive with great care. Do not ex-
ceed a speed of 80 km/h (50 mph). Ob-
serve local speed limits.
CAUTION
l If you sense any abnormality while driving,
stop the vehicle and contact a MITSUBISHI
MOTORS Authorized Service Point or an-
other specialist. Otherwise the tyre pressure
may drop before the emergency repair pro-
cedure is completed, rendering the vehicle
unsafe.
NOTE
l Driving faster than 80 km/h (50 mph) can
make the vehicle vibrate.
19. After driving for 10 minutes or 5 km,
check the tyre pressure using the air
pressure gauge on the compressor. If the
tyre pressure has apparently not drop-
ped, the emergency repair procedure is
complete. Continue the process from
step 21.
If the tyre pressure is not sufficient, in-
flate the tyre to the specified pressure
Tyre repair kit
9-17
OGGE17E1
For emergencies
9