Mitsubishi MOTORS Outlander PHEV 2017, Owner'S Manual

Page: 62 / 548

If the charging indicator is not illumina-
ted, charging is not started.
Follow the manual of each quick charg-
er.
NOTE
l When the quick charge connector is connec-
ted to the charge port, the charging indicator
is blinking. When charging is started, the
charging indicator is illuminated.
l If you want to confirm the drive battery level
during charging, open one of the doors or
operate the multi information display switch,
the drive battery level display (F) appears on
the information screen in the multi informa-
tion display.
Although the predicted charging time dis-
play (G) appears, the charging time for the
quick charging is about 30 minutes and dis-
played “--:--” in the screen and you cannot
confirm the remaining charging time.
l Operation noise may be heard from the vehi-
cle body during quick charging.
This noise comes from the operation of the
drive battery cooling system, and it is not a
malfunction.
l Since the drive battery cooling system uses
cool air of the air conditioning, the air condi-
tioning is automatically operated.
After quick charging, if the area under the
vehicle is wet, transparent and loose, it is de-
humidified water from the air conditioning
and not a malfunction.
7. Charging is complete when the charging
indicator turns off.
Disconnect the quick charge connector
according to the manual of the quick
charger.
CAUTION
l As the quick charge connector is heavier in
comparison to the normal charge connector,
allowing it to drop could cause damage to
the vehicle or charge connector or personal
injury. When removing the connector, be
sure to pull it out straight and as carefully as
possible.
l Do not leave the quick charge connector
connected to the quick charge port after
charging.
Doing so, someone might stumble and it
could cause an injury or the quick charge
port might be damaged by playing it.
NOTE
l Although it is possible to start the electric
motor unit if quick charging has not finished
normally, the charging indicator is continu-
ously blinking. In such a situation, perform
quick charging again and finish it normally
or contact a MITSUBISHI MOTORS Au-
thorized Service Point.
8. Close the inner lid and press the rear of
the charging lid until it clicks to close it.
WARNING
l After charging, be sure to close the inner
lid and the quick charging lid completely.
Be careful that water or dust does not en-
ter in the quick charge port, inner lid and
quick charge connector.
Entry of water or dust could cause fire,
electric shock or short circuit.
l After charging, be sure to disconnect the
charge connector from the charge port.
If the charge connector is only partially
engaged and the connector latch is un-
locked, you could put the operation mode
of the power switch in “ON” and the vehi-
cle could start moving. It could lead to an
unexpected accident.
NOTE
l
If the operation mode of the power switch is
put in ON with the quick charge connector
connected to the quick charge port, the plu-
gin hybrid EV system cannot be started.
Be sure to disconnect the quick charge con-
nector before start.
l Charging may be completed before full
charge. This is a control for efficient charge
and not a malfunction.
To achieve full charge, repeat charging from
Step 5 again.
Quick charging (charging method with quick charger)*
3-19
OGGE17E1
Charging
3