Mitsubishi Heavy Industries FDCW100VNX-A, Technical Manual

Page: 154 / 315

Control
'19 • HM-T-340
Disconnect all users
. n o tt u b K O e h t s s e r p d n a " s r e s u l l a ff o h c ti w s “ k r a M . 1
2.
The installation now communicates with myUpway™ to
release your installation from all users connected via the
internet.
NOTE
After disconnecting all users, none of them can monitor or
control your installation via myUpway™ without requesting
a new connection code
Menu 4.1.3.8 - tcp/ip settings
You can set TCP/IP settings for your installation here.
Automatic setting (DHCP)
1. Tick “automatic". The installation now receives the TCP/IP
settings using DHCP.
. n o tt u b K O e h t s s e r p d n a " m r fi n o c “ k r a M . 2
tcp/ip settings 4.1.3.8
confirm reset
automatic
ip-address
net mask
gateway
dns
Manual setting
1. Untick "automatic", you now have access to several setting
options.
2. Mark “ip-address" and press the OK button.
3. Enter the correct details via the virtual keypad.
4. Mark “OK" and press the OK button.
5. Repeat 1 - 3 for "net mask", "gateway" and "dns".
6. Mark “confi rm" and press the OK button.
CAUTION
The installation cannot connect to the internet without the
correct TCP/IP settings. If unsure about applicable settings
use the automatic mode or contact your network
administrator (or similar) for further information.
TIP
All settings made since opening the menu can be reset by
marking "reset" and pressing the OK button.
Menu 4.1.3.9 - proxy settings
You can set proxy settings for your installation here.
Proxy settings are used to give connection information to a
intermediate server (proxy server) between the installation and
Internet. These settings are primarily used when the installation
If unsure about applicable settings, contact your network
administrator (or similar) for further information.
confirm reset
proxy settings 4.1.3.9
use proxy
server
port
user name
password
Setting
1. Tick “use proxy" if you do not want to use a proxy.
2. Mark “server" and press the OK button.
3. Enter the correct details via the virtual keypad.
4. Mark “OK" and press the OK button.
5. Repeat 1 - 3 for "port", "user name" and "password".
6. Mark “confi rm" and press the OK button.
TIP
All settings made since opening the menu can be reset by
marking "reset" and pressing the OK button.
connects to the Internet via a company network. The installation
supports proxy authentication of the HTTP Basic and HTTP
Digest type.
Control
- 152 -