Mitsubishi Electric PU(H)Y-P250YGM-A, Service Handbook

Page: 64 / 215

- 55 -
[
IV
Indoor Unit Components ]
Drain pan
Heat exchanger
(gas pipe)
Heat exchanger
(liquid pipe)
Unbraze these sections
(2 places on the gas pipe
/upper part of the strainer)
Heat exchanger
(liquid pipe)
Heat exchanger
(gas pipe)
Drain pan
<Model 500>
<Model 500>
<Model 250>
<Model 250>
Unbraze these sections
(2 places on the liquid pipe
/upper part of the strainer)
[Fig. 3]
Top
Bottom
Bottom section of the unit Top section of the unit Bottom section of the unit Top section of the unit
Bottom Bottom Bottom
Top Top Top
Control box
Motor
Control box
Motor
Fan
Supporting
wood piece
Supporting
wood piece
Heat exchanger
Piping side
Heat exchanger
Piping side
Fan
Note
1. Peel off the pipe cover carefully. The cover will be needed again when putting the units together.
2. When loading the unit on an elevator, place the separated sections upright as shown below.
(Place the right side up.) Place a piece of wood at the bottom of the bottom section for support to keep it level.
Unbraze this section
(1 place on the liquid pipe/
upper part of the strainer)
Unbraze these sections
(2 places on the gas pipe/
expanded part)