Mitsubishi Electric PFD-P250VM-E, Service Handbook

Page: 228 / 326

[8-9 Troubleshooting Inverter Problems ]
BS_08_C chapter 8 -
29
8 Troub
le
sho
o
ting Bas
e
d on Ob
ser
ved
Sy
mp
toms
8-9-5 Checking the Inverter for Damage during Compressor Operation
Items to be checked Phenomena Remedy
Put the outdoor unit into opera-
tion.
Check the inverter output volt-
age (at the compressor terminal)
after the inverter output frequen-
cy has stabilized.
<INV35Y, 36Y>
1) Overcurrent-related problems occur im-
mediately after compressor startup.
Error code : 4250
Detail code : 101, 102, 106, 107
a. Check items [8-9-2 Checking the
Inverter Board Error Detection Cir-
cuit] through [8-9-4 Checking the
Inverter for Damage at No-Load]
for problems.
b. Check that high and low pressures
are balanced.
c. Check that no liquid refrigerant is
present in the compressor and that
there is no liquid backflow.
→ Go to "d." when the problem per-
sists after compressor startup was
repeated several times.
d. Check that there is a pressure dif-
ference between high and low
pressures after compressor start-
up.
→ Check the high pressure with
LED monitor for changes.
Replace the compressor if there is
no pressure difference. (the com-
pressor may be locked.)
2) There is a voltage imbalance between
the wires after the inverter output voltage
is stabilized.
Greater than the larger of the following
values: imbalance of 5% or 5V
Replace the INV board if there is a volt-
age imbalance.
Check the belt heater for problems if
there is no voltage imbalance.
→ When the error occurred, liquid refrig-
erant may have been present in the
compressor.
0000004498.BOOK 29 ページ ２０１８年１月５日 金曜日 午前１０時３８分