Mitsubishi Electric PFD-P250VM-E, Service Handbook, Page: 226 / 326

[8-9 Troubleshooting Inverter Problems ]
BS_08_C chapter 8 -
27
8 Troub
le
sho
o
ting Bas
e
d on Ob
ser
ved
Sy
mp
toms
8-9-2 Checking the Inverter Board Error Detection Circuit
*1 Output voltage is present at the inverter output wiring terminal. To avoid short-circuiting and ground fault, do not let the
terminal come in contact with the unit or the compressor, and use caution not to damage the terminal.
*2 Compressors on P200, P250, and P300 models are located in the back of the MAIN BOX. To disconnect the inverter output
wiring, move the MAIN BOX out of the way first, and then disconnect the wiring from the terminal on the compressor. Refer
to [8-12-1 Ensuring Maintenance Space (Preparation for the Maintenance of Refrigerant Circuit Parts)] for how to move the
MAIN BOX.
8-9-3 Checking the Compressor for Ground Fault and Coil Resistance Problems
Items to be checked Phenomena Remedy
(1) Stop the unit.
Remove power supply.
1) Overcurrent error
Error code: 4250
Detail code: No. 101, 104, 105, 106, and
107
Replace the INV board.
(2) Disconnect the inverter
output wires from the
compressor terminals (U,
V, W).
*1
2) Logic error
Error code: 4220
Detail code: No. 111
Replace the INV board.
(3) Apply power supply. 3) ACCT sensor circuit failure
Error code: 5301
Detail code: No.117
Replace the INV board.
(4) Put the outdoor unit into
operation.
4) IPM open
Error code: 5301
Detail code: No.119
Normal
Items to be checked Phenomena Remedy
Disconnect the compressor wir-
ing, and check the compressor
Meg, and coil resistance.
1) Compressor Meg failure
Error if less than 1 M Ω .
Check that there is no liquid refrigerant
in the compressor.
If there is none, replace the compres-
sor.
2) Compressor coil resistance failure
Coil resistance value of 0.325 Ω
(20°C [68°F]): P250 model
Replace the compressor.
0000004498.BOOK 27 ページ ２０１８年１月５日 金曜日 午前１０時３８分