289
FR-E500 series operation panel (PA02) setting
(b) Method to set frequency only without adjusting gain analog value
(When changing the gain frequency from 60Hz to 50Hz)
Operation Display
1.
Confirm the operation status indicator and
operation mode indicator
The inverter should be at a stop.
The inverter should be in the PU operation mode
(depends on
).
2.
Press
to choose the parameter setting
mode.
3.
Turn
until
appears.
4.
Press
to display
.
5.
Turn
until
appears. Turn the dial to
C24 (Pr.923) Frequency setting voltage gain frequency
(built-in potentiometer)
6.
Press
to show the present set value.
7.
Turn
to change the set value to "50.00".
8.
Press
to set.
Flicker...Parameter setting complete!!
(Adjustment completed)
Turn
to read another parameter.
Press
to return to the
indication (step 4).
Press
twice to show the next parameter (
).
REMARKS
To use the built-in frequency setting potentiometer (
Pr.146
= "0") to operate at a frequency higher than 60Hz, change
C24
and
C25 (Pr.923)
settings. Simply changing the
Pr.1
and
Pr.18
settings does not enable the operation at a frequency higher than
60Hz.
Setting of
Pr. 146, C22 (Pr. 922), C23 (Pr. 922), C24 (Pr. 923), C25 (Pr. 923)
can be performed from the inverter operation panel.
However, it can be performed only when the operation panel PA02 for the FR-E500 is connected.
When setting frequency, parameter, etc. using the operation panel PA02, it is necessary to hold down the
key for 1.5s.
Past four faults are stored in the faults history when the operation panel PA02 is connected.
All faults (E.ILF, E.IOH. E.AIE, E.CDO, E.PTC, E.SOT, E.PID, E.SAF) added to the FR-F700PJ series are displayed as E.14.
The parameter
number read
previously appears.
C0 to C25 settings
are enabled.
Hz
A
Hz
A
Hz
A
Summary of Contents for FR-F700PJ Series
