Mitsubishi Electric CC-Link IE-NZ2GNSS2-16DTE, User Manual

Page: 18 / 170

16
2 PART NAMES
2
PART NAMES
The part names of the safety remote I/O module are listed below.
No. Name Description
(1) P1 A port for the connection to CC-Link IE TSN (RJ45 connector)
Connect an Ethernet cable. (

Page 47 Wiring of Ethernet Cable)
There are no restrictions on the connection order of the cables for P1 and P2.
L ER LED Indicates the port status.
On: Abnormal data received or loopback being performed
Off: Normal data received and loopback not performed
LINK LED Indicates the link status.
On: Link-up in progress
Flashing: Communicating (100Mbps)
Off: Link-down in progress
P2 Same as P1
L ER LED
LINK LED
(2) PW LED Indicates the power supply status of the safety remote I/O module.
On: Power supply ON
Off: Power supply OFF
RUN LED Indicates the operating status of the safety remote I/O module.
On: Operating normally, in initial processing
Flashing: Operating in unit test mode
Off: A major error has occurred.
D LINK LED Indicates the data link status of the safety remote I/O module.
On: Cyclic transmission being performed, in initial processing
Flashing: Cyclic transmission stopped
*1
Off: Disconnected
SAFETY LED Indicates the safety communications status of the safety remote I/O module.
On: In safety communication connection, in initial processing
Flashing: Checking the position of the setting target module
Off: Safety communication being disconnected
ERR. LED Indicates the error status of the safety remote I/O module.
On: A moderate error or major error has occurred, in initial processing
Flashing: A minor error has occurred.
*2
Off: Operating normally
(3) IP address setting switch Sets the fourth octet of the IP address. (  Page 37 IP Address Setting Switch Setting)
(4) I/O LED When error
points are not
indicated Indicates the ON/OFF status of I/O.
On: ON status of input or output
*3
Off: OFF status of input or output
When error
points are
indicated Flashes the error points.
On: ON status of input or output
*3
Flashing: An error has occurred.
*4
Off: OFF status of input or output
(5) I/O PW LED Indicates the status of the power supply from the external power supply.
On: External power supply ON
Off: External power supply OFF
(6) Terminal block for module
power supply and FG A terminal block to connect the module power supply (24VDC) and FG.
(6) (7) (8)
(3)
(1) (2) (4) (5)