Mitsubishi Electric CC-Link IE-NZ2GNSS2-16DTE, User Manual

Page: 136 / 170

134
APPX
Appendix 2 Remote Control/Monitor Signals
Details of remote control/monitor signals
External input signal
The following table lists the assignment of the external input signals.
Do not read or write data from/to the use-prohibited areas. If data is read or written, the correct operation of
the safety remote I/O module cannot be guaranteed.
■ External input signals (RX0 to RX7)
These signals are external input signals from the safety remote I/O module to the master station. These signals can be used
only in the safety drive mode.
For details on the safety drive mode, refer to the following.

Page 31 Operation mode and state transition
When "Wiring selection of input" is set to "3: General single", the corresponding external input signals (RX0 to
RX7) are fixed to OFF.
Device number Name
RX0 External input signal X0
RX1 External input signal X1
RX2 External input signal X2
RX3 External input signal X3
RX4 External input signal X4
RX5 External input signal X5
RX6 External input signal X6
RX7 External input signal X7
RX8 to RXF Use prohibited