MIMAKI UJF-605RII, Operation Manual

Page: 18 / 170

- xvi -
Cautions for Installation
CAUTION
Notes on UV lamp
• The UV lamp performance and service life are significantly affected by the UV irradiation
and the UV power supply units used. Do not use any UV devices that are not
recommended by MIMAKI. MIMAKI is not responsible for any damage or loss caused by
the use of unauthorized UV devices.
• When handling the UV lamp or the silica glass on the bottom of the UV irradiation device,
be sure to wear the gloves provided and never touch them with bare hands, or the UV ink
curing level is significantly lowered. If the UV lamp or silica glass gets dirty, wipe it off with
clean gauze moistened with alcohol. (Do not use alcohol for cleaning the exterior cover, or
the paint will peel off.)
• Securely mount the UV lamp to the socket, or the lamp may fall out become overheated.
CAUTION
A place which receives direct sunlight
• Do not install printer in any place where
it will be subjected to direct sunlight.
A place where the temperature and humidity
fluctuate greatly
• Use the device under the following
operating environment.
15 to 30 ° C (59 to 86 ° F)
35 to 65% (Rh)
A place which receives direct air blowing
from air conditioner, etc.
• Do not install the printer in any place
where the wind blow directly from an
air conditioner, etc or the ink may get
scattered.
A place that is not horizontal
• Do not install the printer in any place
which is not horizontal and stable, or
you may not be able to print normally.
A place that vibrates
• Do not install the printer in any place
which shakes, or you may not be able to
print normally.
A place which is permeated with dust or
cigarette smoke
•
Do not install the printer in any place
which is permeated with dust or
cigarette smoke, or the dust may
adhere to the printer and cause the
deflection phenomena of ink drops.