MIMAKI UJF-605RII, Operation Manual

Page: 154 / 170

- 6-6 -
The control circuit board is
defective.
The control circuit board is
defective.
POWER+5V
POWER+35V
The control circuit board is
defective.
The printer has received data
other than the command data.
The interface cable used is not in
conformance with this printer.
Error Messages
Error messages indicates error numbers.
If any error message is given on the LCD, turn off the power to the printer and turn it on
after a while.
If the same error message appears again on the LCD, contact your local MIMAKI distribu-
tor or MIMAKI office to call for service.
ERROR 01
MAIN ROM
Turn off the power to and turn it on
after a while. If the same error
message appears again on the
LCD, contact your local distributor
to call for service.
Securely connect the interface
cable in position.
Use an interface cable in conform-
ance with the standard.
Error message Cause Corrective measures
ERROR 07
DFC ss
ERROR 06
UHC ss nnnn
ERROR 05
FPGA-ss
ERROR 04
FLASH SAVE
ERROR 03
POWER +35V
ERROR 03
POWER +5V
ERROR 02
MAIN RAM
Check the host computer output
setting.
Check the printing area.
ERROR 10
COMMAND
ERROR 11
PARAMETER
ERROR 12
OFF SCALE
A parameter outside the range of
acceptable numeric values is
received.
The data is printed out of the
printing area.
ERROR 13
MEMORY DATA
When each edition has different
resolution or there is the same
color during receiving data in the
MEMORY mode, it is displayed. In case of copying multi editions,
use the data which has the same
resolution and which there is not the
same color in each edition.