© 2011 MIMAKI ENGINEERING CO.,LTD.
4.3.1
P.2
4.3.1 Adjustment of the Mounting Location for the Cutter
5. Align the front and back of the cutter unit. Lower the cutter
blade until it fits into the fitting, and then determine the front
and back position of the unit and fix it using the screws.
6. Move the head unit manually and push down the cutter blade
assy at each right, center and left end on the platen, to check
back-front positioning.
The fitting area is wider than the actual cutter blade.
Therefore, alignment should be made within that
area.
If the jig is not available, press the cutter blade assy
down to the platen surface and adjust it until it fits the
platen.
On rare occasions, the blade comes out of the slot
because of assembly errors or fluctuation in part
accuracies. In such a case, adjust again to the back-
front optimum position where the blade is always in
whole slot on the platen.
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Adjustment of the Mounting Location for the Cutter
Model
TS34-1800A
Issued 2011.10.17 Revised
F/W ver.
1.20
Remark
1.0