MIMAKI SWJ-320 S2, Maintenance Manual

Page: 167 / 210

© 2013 MIMAKI ENGINEERING CO.,LTD. 6.6.5 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Disassembly and Reassembly > Pressurizing relations > Lighting LED assy.
Model SWJ-320S Issued 2012.07.19 Revised F/W ver Remark
1.0
Rev.
6.6.5 Lighting LED assy.
 Work procedures
1. Turn off the main power supply and remove the power plug
from the main body.
2. Unscrew the screws, and remove the bracket of the purge part.
3. Disconnect the relay connector of the lighting LED assy.
4. Unscrew the screws, and remove the bracket of the lighting
LED assy. .
キ
5. Unscrew the screws, and remove the lighting LED assy. from
the bracket.
6. Reverse the disassembly procedure for reassembly.
After turning off the sub and main power switches, unplug the power cord. Make sure to take 15
minutes before restarting the operation. It is very dangerous if sleep mode functions mistakenly
during the operation.
Additionally, if electric charges are still remaining, it may cause damage to electronic parts or the like.
Lighting LED assy.
Connector
Inside of bracket of the purge part
Bracket of the lighting LED assy.
Bracket of the purge part.
For the lighting LED cover, handle it with care
not to damage since the glass has been used.
screw(x2)
Bracket of the lighting LED assy.
Lighting LED cover
Glass: Attention to damage.
Lighting LED assy.
Lighting LED
inside cover