MIMAKI SWJ-320 S2, Maintenance Manual

Page: 73 / 210

© 2013 MIMAKI ENGINEERING CO.,LTD. 4.2.11 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Adjustment > Adjustment Items > CAPPING
Model SWJ-320S Issued 2012.07.19 Revised F/W ver 1.0 Remark
1.0
Rev.
4.2.11 CAPPING
 Outline
 Adjusts the location for capping and wiper. Adjusted value is saved in the system parameter.
 Basically, it is not necessary to make adjustment even when cap assy. has been replaced.
 Work Procedures
1. Turn the head height adjustment knob screw and set the head
height to the lowest position (PG:2mm).
2. Select [#ADJUST CAPPING].
3. Move the carriage so that the leg of the cap base (cap link)
becomes vertical.
[

]/[

] : Move carriage (adjust)
[ENTER] : Set
4. Adjust the air suction position.
1), From the position where the heads and caps are separated,
press the [

] key.
2),The back side of the caps will come into contact with the
heads first.
From that position, continue pressing the [

] key.
Stop at the position where, among all of the heads, at least
one of them comes into contact with the front side of a cap.
3), From the position where the front side of a cap comes into
contact with a head, press the [

] key 10 times. (Shift the
carriage 1.0 to the left)
[

]/[

] : Move cap (adjust)
[ENTER] : Set
#ADJUST
CAPPING
[ENT]
#CAPPING
CAP POS.
= 2.0
Adjust the posi-
tion so that it
becomes vertical.
Carriage
Cap base
-20.0~20.0
#CAPPING
AIR PULL POS. = 2.0
Near side
of device
Back of
device
From the position where the front side of a cap
comes into contact with a head, adjust “1.0” to
the left.
-20.0~20.0
Check/Adjust the followings, if not properly adjust-
able.
 Head height
 4.3.1 Cap height adjustment