MIMAKI SWJ-320 S2, Maintenance Manual

Page: 176 / 210

© 2013 MIMAKI ENGINEERING CO.,LTD. 6.8.1 P.1
R.1.0
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Disassembly and Reassembly > Heater relations > Temperature controller
Model SWJ-320S Issued 2012.07.19 Revised F/W ver Remark
1.0
Rev.
6.8.1 Temperature controller
 Work procedures
1. Turn off the main power supply and remove the power plug
from the main body.
2. Open the left electrical BOX cover.
3. Disconnect all of the cables connected on the backside of con-
troller.
4. Remove the mounting adapter by widening the top and bottom
hook parts of mounting adapter by a flat-blade screwdriver or
the like and pulling it to the front direction.
キ
5. Reverse the disassembly procedure for reassembly.
At connecting, connect them surely, referring to the table below.
PRINT
PRE
POST
After turning off the sub and main power switches, unplug the power cord. Make sure to take 15
minutes before restarting the operation. It is very dangerous if sleep mode functions mistakenly
during the operation.
Additionally, if electric charges are still remaining, it may cause damage to electronic parts or the like.
Outside of Left electrical box cover
POST
Inside of Left electrical box cover
PRE PRINT
POST
PRE PRINT
Widen the hook
Mounting adapter
Temperature controller
Wiring diagram
Terminal diagram viewed from the
backside of controller
POST PRE PRINT
Terminal No. Wire marker Terminal No. Wire marker
1 A36 6 ––
2 A37 7 ––
3 –– 8 RT3
4 17 9 RT33
5 16 10 ––
Terminal No. Wire marker Terminal No. Wire marker
1 A33 6 ––
2 A34 7 ––
3 –– 8 RT2
4 15 9 RT22
5 14 10 ––
Terminal No. Wire marker Terminal No. Wire marker
1 A30 6 ––
2 A31 7 ––
3 –– 8 RT1
4 13 9 RT11
5 12 10 ––