![background image](http://html.mh-extra.com/html/miele/kfn-14827-sde-ed-cs-2/kfn-14827-sde-ed-cs-2_operating-and-installation-instructions_236539088.webp)
Changing the door hinging
88
Refitting the lower door
Unscrew the set screw
by one turn
using the Allen key supplied.
Pull the hinge pin
complete with
the washer
and adjusting foot
upwards to remove.
Remove the stopper
.
Undo the screws
and remove the
hinge plate
.
Unscrew the hinge part
from the
hinge plate
, turn it 180°, and screw
it into the opposite hole in the hinge
plate.
Insert the stopper
into the other
hole.
Unscrew the set screw
completely
with the Allen key.
Screw the set screw
into the hinge
plate on the opposite side until the
screw sits flush with the outer edge of
the hinge plate. Make sure that the
end of the set screw protrudes far
enough from the hinge pin hole so
that it can fit into the groove in the
hinge pin later (see following picture).
Remove the cover
and fit it into the
holes on the opposite side.
Screw the hinge plate
onto the
opposite side, using only the outer
two slots. Do not use the middle hole
because you will not be able to align
the door later on.
Important: Screw the adjustable
foot
into the hinge pin
as far as
it will go.
Place the entire hinge pin
complete with the washer
, foot
,
and groove onto the end of the set
screw and screw it in.
Tighten the set screw
.
Place the lower door on the hinge
pin
from above.
Close the lower appliance door.
Summary of Contents for KFN 14827 SDE ed/cs-2
Page 94: ......
Page 96: ...M Nr 09 574 230 05 en AU NZ KFN 14827 SDE ed cs 2 ...