Micsig ATO1000 Series, User Manual

Page: 215 / 219

212
Slope rising edge, falling edge, arbitrary
Timeout positive, negative, arbitrary
Video
Type: odd field, even field, all fields, all lines, lines
System: PAL, NTSC, SECAM, 720P, 1080I, 1080P
UART (RS232/RS422
/RS485)
Trigger on sending start bit, stop bit, data, 0 data, 1
data, X data, parity error within 10 Mb/s
LIN
（
optional
）
Trigger on synchronous rising edge, frame ID, frame
ID and data within 100 kb/s (20 kb/s defined by LIN).
CAN
（
optional
）
Within 1 Mb/s CAN signal frame start, frame type
(data, remote, error, overload), identifier (standard or
extended), data, identifier and data, end of frame,
missing ACK, or bit stuffing error.
You can further specify the data to be used to trigger
when
≤ , <, =, >, ≥ or ≠ a special data value.
The user-adjustable sampling point is set to 50% by
default
SPI （ optional ）
Trigger on SS activation, frame start, MOSI, MISO,
or MOSI and MISO on the SPI bus within 50.0 Mb/s
I2C （ optional ）
Trigger on start, repeated start, stop, lost ACK,
address (7 or 10 bits), data, or address and data on the
I2C bus within 10 Mb/s.
ARINC429
（
optional
）
1553B
（
optional
）
Trigger coupling mode
DC, AC, HF suppression, LF suppression, noise
suppression
Trigger hold-off time range 200ns~10s
measurement
Measurement type
cycle, frequency, rise time, fall time, positive duty
ratio, negative duty ratio, delay, positive pulse width,
negative pulse width, burst pulse width, positive
overshoot, negative overshoot, phase, peak peak peak
value, amplitude, high, low, maximum, minimum,
average, cycle average, root mean square, cycle root
mean square
Cursor type horizontal cursor, vertical cursor, cross cursor
Math