e) Daily: cleaning the mixer unit
The mixer unit must be cleaned on a
daily
basis as it
contains traces of milk products:
Disassembling the mixing unit:
!
Pull the
outlet tube for instant products
out
completely both from the mixer housing and the
beverage outlet spout at the front.
"
Turn
powder chute
for instant products to face
upwards and …
#
remove
instant product container
by lifting it
and pulling it forward. You can pull off and
remove the powder chute for cleaning.
$
Loosen the
mixer flange
by turning its small
lever anti-clockwise.
%
You can now remove the whole
mixer housing
by pulling it forward and out of the machine.
➀
Remove the
mixer propeller
by simply pulling it
off its axle it only sits loosely on the axle.
$
You can now remove the loosened
mixer flange
.
Cleaning the mixing unit:
❍
Now clean all parts thoroughly with hot water and
a
detergent suitable for milk products
.
❍
Rinse thoroughly in clean water and leave until
completely dry.
❍
Clean the uncovered end of the feed screw at the
instant product container with a dry dusting
brush. This is the position where the powder
chute was removed.
Re-assembling the mixing unit:
Now re-assemble all parts in the reverse order.
Please note:
➀
Replace
mixer propeller
with the
marking
(arrow) to the
flattened side
of the axle.
!
The
outlet tube for instant products
must be
pushed completely onto the connection muffs of
the mixer unit and, at the front end,
pushed
down fully
into the beverage outlet spout.
24
“Re-assembling” continued on page 25
GB
"
!
$
%
➁
$
➀
Ausgedruckt von Pressworks.
18:47 27.01.106
Datei 12-25.dtp, Seite 13.
