12
9. Setting up
When the machine has been installed, connected and
prepared for operation according to the above instruc-
tions, you can now set it up (filling and programming)
for dispensing products:
a) Switching on
You can switch the machine on before filling, so that it
already starts heating up. To do this... !
❍
turn the
water tap
on,
!
open the
door
, using the key and …
"
switch the
mains supply
on.
❍
insert the
spray protection plate
(p.11). Very hot
water is dispensed during the warming-up phase
there is thus a
danger of scalding
!
b) Filling ground coffee
#
After opening the machine door: open the
housing lid
and ...
➀
lift the
cover
of the ground coffee container.
$
Now you can fill the
ground coffee container
and then close everything again.
➁
Caution
do not mix up containers! The rear
container is for ground coffee. This is clearly
indicated by the
sticker in the lid
.
c) Filling instant powder
%
When the machine door is open: turn the
powder
chute upwards
and …
&
remove the
instant product container
by lifting
it slightly and pulling away from the machine.
➂
Take the
instant container cover
off. Now you
can fill in the instant powder (don´t press down!)
and immediately replace the cover. Please
ensure that the
lip of the cover points forward
.
❍
eplace the instant product container in such a
way that the
pin at the front
of the container
bottom …
➃
clicks firmly into the
hole on the bottom
of the
instant product compartment. Only then is the
container correctly installed again.
%
Before closing the machine door, don´t forget to
turn the powder chute down
into the funnel
again.
Now close the door
and observe the display
message.
&
%
➂
➃
"
$
➁
#
➀
GB
Ausgedruckt von Pressworks.
16:58 01.06.105
Datei 12-25.DTP, Seite 1.
