Chapter 5 – Logging
33
No
and
Immediate printout Yes
.
In order to output logs immediately,
Immediate printout Yes
must be set.
In order to save the setting and to leave the menu again, press the
K
EY
(S). The display shows
Function: Print
By again pressing the K
EY
(S), you leave the menu completely and
return back to the initial state.
NOTICE:
If it is not possible to output a log report for the immediate output because
for example the activated output medium is not connected, a warning
message appears. MELAG recommends that you employ the immediate
output of logs.
Output the logs subsequently
You also have the option of outputting the logs subsequently and
independently from the time of the end of the program. You can select
whether selected or all saved logs (up to 40 logs) should be printed.
For this, use the connected output medium, e.g. the log printer.
Print selected logs
In order to subsequently print selected logs of certain programs, proceed
as follows:
Select the SETUP Menu
Function
by short simultaneous pressing
of the keys (+) or (-). The display shows
Function: Print
.
Press the K
EY
(P). The Menu
Print – File transmission
is
displayed.
Navigate with the K
EY
(+) or (-) until the display
last cycle Print: No. 40
is shown (as example No. 40).
Press the K
EY
(P). The current report number blinks.
In order to print a log of another cycle, navigate with the
KEYS
(+) or (-)
up to the desired number, here e.g. 25.
Press the K
EY
(P) in order to start the printout of the selected
program. The display shows
Printout
.
After finished printout, the display changes again to its previous setting
Last cycle Print: No. 25
.
In order to print additional logs, repeat the last three steps.
In order to leave the submenu without printing, press
the K
EY
(S).
In order to leave the menu after printing, press the K
EY
(S). The
display shows the menu
Function: Print
.
By again pressing the K
EY
(S), you completely leave the menu and
return back to the basic position of the display.
Print all saved logs
Program
Start-Stop
In order to subsequently print all saved logs, proceed as follows:
Select the SETUP Menu
Function
by short simultaneous pressing
of the keys (+) or (-).
The display shows
Function: Print.
Press the K
EY
(P). The Menu
Print – File transmission
is
displayed.
Navigate with the K
EY
(+) or (-), until the display
Print stored cycles
is displayed.
Press the K
EY
(P) in order to start the printout of the selected