MELAG Vacuklav 24 B+, Technical Description, Page: 26 / 57

Chapter 4 – Sterilization
26
ƒ Press the K
EY
(S).
ƒ
Confirm the following prompt
Stop program?
Repeatedly press
"Stop"
with the K
EY
(S).
The termination is confirmed with
Drying stopped
on the display.
NOTICE:
The confirmation prompt is shown for about 5 seconds on the display. If
the key is not repeatedly pressed, the program continues with the normal
process.
Program
Start-Stop
After the ventilation of the chamber with a corresponding display text the
message
Quick Program run successfully
follows in alternation
with
Please open door
.
If a printer is connected to the autoclave and the
Immediate printout
is set to
yes
, a reference to
Drying stopped
is issued to the logging
printout.
Sterilization phase is finished
Sterilization phase
successfully finished
You can recognize on the display whether the sterilization phase has
successfully completed.
The remaining time of the sterilization phase is displayed in alternation
with the specification of the pressure and temperature.
Sterilization not successfully
finished
The sterilization is not successful if it was terminated by the operator or
aborted by the system in the event of an error.
Program abort by the system
At a system abort, the system puts the chamber into a pressureless state.
NOTICE:
If the program is terminated by the operator, a warning text appears. If the
program is aborted by the system, an error message is displayed.
Drying phase
The autoclave does an excellent job of drying the items to be sterilized. In
the event of difficult drying tasks it might however be necessary to take the
following measures to further improve drying:
Improve drying results
ƒ Load the autoclave correctly for drying. Place items wrapped in
sterilized clear plastic or paper upwards like filing cards.
Observe Section
Load the autoclave
on page
20
. Possibly employ
the package holder.
ƒ Activate the function
Supplement Drying
. Observe the Section
Select
additional drying
on page 24.
Program is finished
Program
Start-Stop
The chamber pressure is adapted to the ambient pressure at the end of a
program. An appropriate display message
Ventilation
is shown. If the
program was successfully finished, an appropriate notification appears on
the
→ display.
Immediate printout
The report of the completed program is issued to the selected output
medium for activated immediate printout (see page 29,
Chapter 5 –
Logging
).