MDT Technologies BE-GT20S.01, Technical Manual

Page: 27 / 90

Technical Manual
Glass Push Button II Smart & Push Button Smart 86
MDT technologies GmbH, Geschäftsbereich Gebäudeautomation
Phone: +49-2263-880
•
Fax: +49-2263-4588
•
E-Mail: knx@mdt.de
•
www.mdt.de
27
27
Color of message text
Any color
[Red]
Setting of the color for the
message text
Indicate a message via
LEDs

No

Yes
Setting if the LEDs should flash
at an active message
Color of LEDs Any color
[Red]
Select the colour in which the
LEDs display the message.
Only visible if "Indicate message
via LEDs" is activated
.
Table 14: Settings – Messages/Alarms
The message behavior depends on the parameter "Standby display at day / night". The different
behaviors are shown below:
Standby display Incoming message during standby
no Standby

No message is displayed but saved
Standby in upper
keypad

Message is displayed on upper button pair and the upper LEDs
change between parameterized color and black at 600ms pulse

At the same time, the parameterized color is set to double
brightness in order to increase the signal effect

The message is only acknowledged by pressing to one of the
upper buttons.

A keystroke on the middle and lower buttons performs the
displayed switching functions
Standby on full screen

Message is displayed in the middle of the screen and all LEDs
change between parameterized color and black

At the same time, the parameterized color is set to double
brightness in order to increase the signal effect.

The message is acknowledged by pressing to any key
Display off

No message is displayed during standby but saved.

The message with the highest priority is indicated by the
keystroke after standby

The displayed messages are acknowledged by means of further
key strokes

Message is displayed in the middle of the screen and all LEDs
change between parameterized color and black

At the same time, the parameterized color is set to double
brightness in order to increase the signal effect.
Display off and
orientation-LED on

Message is displayed in the middle of the screen and all LEDs
change between parameterized color and black

At the same time, the parameterized color is set to double
brightness in order to increase the signal effect.

After the "timeout for standby", the LEDs will stop flashing and
the message dispappears.

If any button is pressed after the LEDs have stopped flashing, the
message with the highest priority is displayed again. Further
keystrokes acknowledge the messages
Table 15: Behavior of the device to an incoming message during standby