Technical Manual
Glass Push Button II Smart & Push Button Smart 86
MDT technologies GmbH, Geschäftsbereich Gebäudeautomation
Phone: +49-2263-880
•
Fax: +49-2263-4588
•
E-Mail: [email protected]
•
www.mdt.de
76
76
4.5 State LED
Depending on the configuration of the push button (1, 2 or 3 levels), up to 14 status LEDs can be
configured. One LED can be configured for each function, which is then marked with 1-12 in the
parameters. From hardware revision R.3.1, LEDs A/B can also be controlled in Standby mode to
indicate a status during Standby, for example.
For the necessary settings, see the chapter "Info display" under "4.2.3.1 Presentation in Standby”.
4.5.1 LED basic settings
The LED basic settings affect all active status LEDs. The following figure shows the available settings:
Figure 49: Basic settings – LED
The table below shows all available settings:
ETS-Text
Dynamic range
[Default value]
Comment
LED-color at button activation,
only by setting “Object and
button activation”
Any color
Parameter is only used at
double assignment: "Keystroke
+ internal / external object"
Lock object for LEDs
not active
active
Activates a lock object which
can disable (= switch off) all
LEDs
Behaviour of LEDs at bus power
up
no read LED objects
read LED objects
Setting whether to actively
request the objects after a
reset.
Only effective with "LED
reacts to external object
"
Synchronization object for
flashing LEDs
not active
active as master
active as slave
Activating a synchronisation
object for the LEDs
Indication of long key press via
status LEDs
not active
active
When activated, a long key
press is indicated by the status
LED going out
Table 69: Basic settings – LED
