Makita PM7651H, Instruction Manual

Page: 21 / 220

20 21
3. Mount another supplied nozzle with a small discharge hole.
NOTE:
●
Choose a right nozzle out of the following two according to the kind (viscosity)
of the chemical you use.
(7) (8)
(9)
(3)
(10)
Nozzle type Viscosity of chemical Example of chemical Discharge rate (L/min)*
1
Aluminum nozzle (silver color) (7) *
2
High MALATHION (Mix the oil.) 0.14
Brass nozzle (gold color) (8) *
2
Low Aqua K-Othrine (Mix the water.) 0.075
Brass nozzle with punch marking
(gold color) (9) *
2
Low Cipermetrinato (Mix the water.) 0.060
Note 1: The discharge rate shown in the table is that in case of water only used for a guide line. This varies by chemicals being used.
Note 2: The type of the nozzle(s) provided with the mist blower changes from country to country.
4. Mount the top nozzle (3) and secure it with the screw (1).
NOTE:
●
When using an above small-amount-solution-discharge nozzle, do not mount the
dispersion cover (4) or deflector (optional accessory) and put it aside so that it is
not lost.
5. Set the knob (10) to the position 4.
(5)
(6)
2. Fit a slotted bit screwdriver to the slit (5) in the nozzle top and remove the nozzle
cap (6) by turning it fully counterclockwise.