MacDon M105, Operator'S Manual

Page: 79 / 384

OPERATOR’S STATION
Display (lower or upper line) Description
#### KNIFE SPEED
#### KNIFE SENSOR (
fl ashing)
Knife speed In strokes per minute. Optional.
8
Sensor Disabled.
##.# HEADER HEIGHT
##.# HEADER SENSOR (
fl ashing)
Distance setting (00.0–10.0) between cutterbar and ground.
Sensor Disabled.
##.# HEADER ANGLE
##.# HEADER SENSOR (
fl ashing)
Header Angle setting (00.0–10.0) relative to ground. Optional.
8
Sensor Disabled. ANGLE and SENSOR alternate at 1 second intervals.
##.# VOLTS Engine electrical system operating voltage.
FUEL | ■■■■ | ■■■■ | Level of fuel in tank.
ENGINE TEMP ### °F
ENGINE TEMP ### °C (if metric) Engine coolant temperature.
SCROLL
SUB-MENU (lower line only)
#### KNIFE SPEED
##.# REEL RPM
##.# DRAPER SPEED
FUEL |
■■■■ | ■■■■ |
Displays sub-menu after 2–3 seconds. Press SELECT to cancel.
Scroll through sub-menu display with CDM switch.
Optional.
8
KNIFE SPD OVERLOAD (lower line) Knife speed is less than programmed set point.
Engine Running, Header Engaged, Draper Header, Index Switch ON
Scroll through display with cab display module (CDM) switch or ground speed lever (GSL) switch.
Display (lower or upper line) Description
#####.# ENGINE HRS
Total engine operating time.
#####.# UNIT HRS
Total windrower operating time.
#####.# HEADER HRS
Total header operating time.
##.# ACRES/HOUR
##.# HECTARES/HOUR (if metric) Actual cutting rate in acres (hectares)/hour.
###.# SUB ACRES
###.# SUB HECTARES (if metric) Area cut since last reset. To reset, display SUB ACRES on lower line
and hold down program switch until display resets (5–7 Seconds).
###### TOTAL ACRES
###### TOTAL HECT (if metric) Total area cut by machine.
##.## ##.# REEL IND
##.## REEL.SENSOR (
fl ashing)
Reel peripheral speed along with ground speed in mph or kph.
Optional.
9
Sensor Disabled.
##.# ##.# DRAP INDX Draper speed along with ground speed in mph or kph.
#### KNIFE SPEED
#### KNIFE SENSOR (
fl ashing)
Knife speed in strokes per minute. Optional
9
Sensor Disabled.
##.# HEADER HEIGHT
##.# HEADER SENSOR (
fl ashing)
Distance setting (00.0–10.0) between cutterbar and ground.
Sensor Disabled.
9. Optional: Available with Expansion Module installation—Whole Goods bundle MD #B4666.
169890
65
Revision A