MacDon M105, Operator'S Manual

Page: 103 / 384

OPERATION
2. Move ground speed lever (GSL) (A) into
N-DETENT (B).
3. Turn steering wheel until it locks. It may be possible to
move the steering wheel slightly in the locked position.
IMPORTANT:
Do
NOT
attempt to force the wheel out of locked position
as damage to the traction system may occur.
4. Fasten seat belt.
5. Push HEADER DRIVE switch (C) to ensure it is OFF.
Figure 4.8: Operator Console
Normal Start
Engine temperature above 60°F (16°C):
WARNING
If starter engages with steering wheel unlocked,
ground speed lever out of NEUTRAL, or header
clutch engaged, DO NOT START ENGINE. See your
Dealer.
1. Set throttle (A) to START position—fully back.
IMPORTANT:
The machine gauges and instruments provide important
information about machine operation and condition.
Familiarize yourself with the gauges and monitor them
carefully during start-up operation. Refer to
3.15 Engine
Controls and Gauges, page 54
.
CAUTION
Check to be sure all bystanders have cleared the area.
2. Sound horn (C) three times.
3. Turn ignition key (B) to RUN position. Single loud tone
sounds, engine warning lights illuminate as a self-test,
and cab display module (CDM) displays “HEADER
DISENGAGED” and “IN PARK”.
4. Turn ignition key (B) to START position until engine
starts, and then release key.
Figure 4.9: Operator Console
IMPORTANT:
• Do
NOT
operate starter for longer than 15 seconds at a time.
• If engine does not start, wait at least two minutes before trying again.
• After the third 15 second crank attempt, allow solenoid to cool for 10 minutes before further cranking attempts.
If engine still does not start, refer to
6.1 Engine Troubleshooting, page 317
.
169890
89
Revision A