LV switch IPPBX3000, User Manual

Page: 29 / 195

LvSwitch IPPBX 3000 Manual
27
3 Device Startup and Configuration
Summary
This chapter describes the procedure for powering on the device and describes how to log in to the
device management system through the Web interface.
The default IP address of the device LAN port is 192.168.100.1/255.255.255.0. Connect the LAN port
of the device to the network port of the PC through a network cable, keep the IP address of the configuration
PC and the LAN port IP address of the device are on the same network Paragraph, configure the device
through the Web page.
3.1 Powering on the device
3.1.1 Check before power
The following checks should be performed before the device is powered on:
1. Check to make sure the power cord and ground connection is correct.
2. Check to make sure the supply voltage and equipment requirements are the same
3. Check to make sure the configure the cable connection is correct, configure the end of the PC is already
open.
3.1.2 Powering on the device
1. Turn on the power switch
2. Turn on the power switch of the device
3.1.3 Inspection / operation after powering the device.
1. Check the indicator on the front panel of the device is normal or not
2. Check the Configure terminal display is normal or not
3. The device will perform normal operation after be powered on 1 ~ 2 minutes and the hardware self-test
copleted, please be patient
3.2 Build WEB configuration environment
3.2.1 Configuration Preparation
Users need to confirm the following items before the configuration:

Using Crossover or Direct Connect Ethernet cable to connect LVswitch IPPBX network interface of
LAN with the user's computer

TCP / IP protocol installed and started

Web browser (IE6.0 or higher) installed