A
Summary of Commands
remove
UCS 1000 R4.2 Administration 585-313-507
Issue 3 April 2000 556
•
-n
— Disables prompting from the system whether to wait until a conflict
is resolved (see the
-i
option below) or to terminate the request to
remove.
•
-i
— Enables secondary command registration. If T1 diagnostics are
being run, this option allows the removal of another card. If -i is used and
another maintenance command is being run
(
remove
,
detach
,
attach
,
restore
,
diagnose), the request to remove
card is blocked and a
message is printed to the screen. If
-i
is not used and any maintenance
command is being run, the request to remove
card is blocked and a
message is printed to the screen.
If the command is permitted to run, a check is made to see if the
command is in conflict with another. A command is in conflict if the card
or card associated with it:
~
Is the T1 card being diagnosed
~
Will cause a change in the existing TDM bus master assignment
~
Has an interdependency with the T1 card being diagnosed (for
example, PRI)
If one of the above conflicts exist and
-n
is not used, the user is asked
whether to wait until the conflict is resolved or to terminate the request. If
T1 diagnostics are executing online tests and a conflict is detected, the
remove card
command is blocked. If T1 diagnostics are executing off-
line tests and a conflict is detected, the user is asked whether to wait until
the conflict is resolved or to terminate the request to remove.
