A
Summary of Commands
restore
UCS 1000 R4.2 Administration 585-313-507
Issue 3 April 2000 559
See Also
attach
detach
restore
restore
The restore command restores a unit to the in-service state.
Synopsis
restore
<unit> <number> [-i] [-n]
Description
The restore command is used to change the permanent state of a unit from
manual-out-of-service (MANOOS) to in service (INSERV). The specified unit
is placed in the INSERV state unconditionally, unless its current state is not
MANOOS.
The parameters for the restore
command are:
•
<unit>
— Identifies the unit. The choices are “channel” or “card.”
•
<number>
— Specifies the channel or card number, a range of channel
or card numbers in the form m-n, or the word “all” for all the channel or
card numbers. Card numbers are in the form card#[.port#]
where
port#
is
