Lenze 8400 motec Series, Software Manual, Page: 327 / 376

Firmware
≤
02.00 - DMS 2.1 EN - 03/2011
L
327
8400 motec | Software Manual
Function library
L_PCTRL_1
C00227 0.0 s 999.9 Acceleration time for the ramp at the
PID output (should be set as steep as
possible)
• Lenze setting: 0.1 s
C00228 0.0 s 999.9 Deceleration time for the ramp at the
PID output
• Lenze setting: 0.1 s
C00231/1 (Pos. Maximum)
C00231/2 (Pos. Minimum)
C00231/3 (Neg. Minimum)
C00231/4 (Neg. Maximum)
0.0 % 199.9 Operating range
• Determination of the operating
range for the PID process
controller by limiting the input
signal nSet_a .
• Lenze setting: No limitation (-
199.9 % ... +199.9 %)
C00242 Operating mode
0 Off
(Lenze setting)
The input setpoint nNSet_a is output
without any changes at the output
nOut_a .
1 Ad feedforward control nNSet_a and nAct_a are used as PID
input values. The arriving nNSet_a is
additively linked to the value output
by the PID element.
2 PID as setpoint generator. nSet_a and nAct_a are used as PID
input values. The input nNSet_a is
not considered.
3 PID setpoint from L_NSet_1 nNSet_a and nAct_a are used as PID
input values. The input nSet_a is not
considered.
C00243 0.0 s 999.9 Influence acceleration time
• Acceleration time T
ir
for the
influencing factor.
• Lenze setting: 5.0 s
C00244 0.0 s 999.9 Influence deceleration time
• Deceleration time T
if
for the
influencing factor.
• Lenze setting: 5.0 s
C00245 -199.9 % +199.9 Display of PID output value
nPIDOut_a
Parameter Possible settings Info