Lenovo 10AX, Maintenance Manual

Page: 155 / 260

Replacing the solid-state drive on the bottom of the optical drive bay
To replace the solid-state drive on the bottom of the optical drive bay, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 136.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 136
4. Pivot the drive bay assembly upward. See “Accessing the system board components and drives” on
page 138.
5. Disconnect the signal cable and the power cable from the solid-state drive.
6. Remove the screw 1 and then carefully slide the solid-state drive bracket upward to remove the bracket
from the bottom of the optical drive bay.
Figure 87. Removing the solid-state drive bracket
Chapter 10
.
Replacing FRUs (machine types: 10B4, 10B5, 10B6, and 10B7)
149