LELY 5.1103.0010, Operator'S Manual

Page: 82 / 192

5-2 Installation
D-H023.0906EN
innovators in agriculture
3. Disconnect the CAN-bus connector (7) from the milking robot.
4. Remove the nut, washer and bolt (
3, fig. 16,
page 5-5) from the strip
(2) and the processor installation bracket (4).
5. Remove the processor (5) from the processor installation bracket.
CAUTION
Make sure no debris c an enter the tubes and the ele c tri c al c onne c tor(s).
6. Clean the outside of the processor and the tubes and cables.
7. Put the processor on a clean and safe place.
Adjust
1. De-register the MQC-C on the milking robot (X-Link) and in the T4C
software.
Close-up
1. Open the ball valve ( 1, fig. 14, page 5-4)
2. Install the middle and the lower cover. (page 7-6)
3. Close the multiple function box (page 7-11).
4. Put the milking robot in operation with the X-Link (page 6-1).
5.1.2 Installation of the Processor and the Sampler
Preparation
CAUTION
Before you install the pro c essor and the sampler, you must do a short rinse.
1. Do a short rinse with the X-link.
2. Take the milking robot out of operation with the X-Link (page 6-1).
3. Open the multiple function box (page 7-11).
4. Remove the middle and the lower cover (page 7-6).
5. Close the ball valve ( 1, fig. 14, page 5-4).
Install the processor
CAUTION
Make sure no debris c an enter the tubes and the ele c tri c al c onne c tor(s).
1. Install the processor (
5, fig. 16,
page 5-5) on the processor
installation bracket.
2. Install the nut, washer and bolt ( 3, fig. 16, page 5-5) on the strip (2)
and the processor installation bracket (4).
3. Connect the CAN-bus connector (7) on the milking robot.