Service Manual JET3
80
Rev. 1.0
Fasten slightly the oscillator with a 7mm open-end hydraulic settings.
Plug in the oscillator cable.
12. If necessary clean the nozzle from both sides with appropriate solvent.
Blow down the nozzle with clean air (pressure 2-6 bar). Focus the air gun exactly in the
middle of the nozzle and blow down for several seconds. First against the nozzle outlet
and then against the nozzle entry. This can be repeated for an unlimited number of
times.
Summary of Contents for JET3 up
