Leibinger JET3 up, Service Manual

Page: 47 / 214

47
5031
5031=The printing speed
much too highly. Drops will
be lost.
Occurs when the print is (permanently) too
fast, the StrokeGo monitoring is disabled
and as a result, the DAC FIFO run over.
Printing is too fast.
Reduce the production speed if
possible.
Increase the stroke distance if
possible.
Use a different speed mode to get
a higher possible production
speed.
Use a smaller font in the print job
to reduce the maximum size of
drops in the height.
5042
5042=Drop calculation too
slow Occurs when the print speed is permanently
too fast.
Reduce the production speed if
possible.
Increase the stroke distance if
possible.
Use a different speed mode to get
a higher possible production
speed.
Use a smaller font in the print job
to reduce the maximum size of
drops in the height.
Increase the distance between
the different prints.
5043 5043=Mailing buffer empty
Mailing buffer empty.
During a print another print go appears and
causes that the buffer is getting empty.
Check the print go sensor for
double trigger and if possible
adjust the sensitivity.
Use „hold of distance“ to ignore
double trigger.
See 0perating manual JET3up
Figure 8.5.1.4 / Page
196ReleaseR1.06