LEGRAND Server Technology PRO3X, User Manual, Page: 46 / 182

Using the PRO3X Command Line Interface (CLI)
PRO3X User Guide – Command Line Interface (CLI)
46 of 182
<mode> is one of the modes:
dhcp or static .
Mode Description
dhcp The IPv4 configuration mode is set to DHCP.
static The IPv4 configuration mode is set to static IP address.
Setting the IPv4 Preferred Host Name
After selecting DHCP as the IPv4 configuration mode, you can specify the preferred host name, which is optional. The
following is the command:
config:# network ipv4 interface <ETH> preferredHostName <name>
Variables:
<ETH> is one of the network interfaces: ETH1/ETH2 , WIRELESS , or BRIDGE . Note that you must choose/configure the bridge
interface if your PRO3X is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface function. The IP parameters of ETH1/ETH2
and WIRELESS interfaces do NOT function.
Interface Description
eth1 Determine the IPv4 preferred host name of the ETH1
interface (that is, wired networking).
eth2 Determine the IPv4 preferred host name of the ETH2
interface (that is, wired networking).
wireless Determine the IPv4 preferred host name of the
WIRELESS interface (that is, wireless networking).
bridge Determine the IPv4 preferred host name of the
BRIDGE interface (that is, bridging mode).
<name> is a host name which:
▪
Consists of alphanumeric characters and/or hyphens
▪
Cannot begin or end with a hyphen
▪
Cannot contain more than 63 characters
▪
Cannot contain punctuation marks, spaces, and other symbols