Label I Feed Good L, Technical Manual

Page: 11 / 132

i • FeedGood
L
• Technical Guide | 9
Connections
i • FeedGood
L
is connected via two MS/MIL-­C5015 series
connectors, two M12 series connectors and a C16-­3
®
series
Amphenol connector.
Note : before performing the connections, make sure that the
scale and accessories are off.
The
POWER/ALARM connector is where power supply and the
alarm device are connected. It is set up for connection of the
Power and Alarm Cable which can be identified by the red tag.
The
SENSOR connector is where the load cells are connected. It
is set up for connection of the Load Cells Extension Cable
identified by the blue tag.
The
COM A connector is where the printer or modem is
connected.
The
L-­LINK connector is where the Remote L-­Link Terminals or a
CAN-­Bus device is connected.
Note : i • FeedGood
L
is supplied with the L-­Link Port terminated
(JP12-­LA.S4 PCB closed on C-­A). This setting is right if only one
Remote Terminal or one CAN-­Bus device is connected to L-­Link
Port. If you connect more Remote Terminals or CAN-­Bus devices,
contact Customer Service to know the precautions to be taken for
the correct connection. To swtich off the termination on the
L-­Link Port close the JP12 jumper on C-­B (see photo 1).
The
T-­DATA Giga connector is where the T-­DATA Giga device is
connected.
Further connectors could be present depending on the options
purchased. See the documentation supplied together with the
options and accessories for the connections.