Label I Feed Good L, Technical Manual

Page: 98 / 132

96 | i • FeedGood
L
• Technical Guide
Memories
The Test verifies operation of the memories of the scale and of
the
T-­DATA Giga device.
1. To conduct the Test of all the memories, select the item
“ALL”;; to conduct the Test of a single memory select the type
of memory you want to check, then press
u .
The display shows the message "Test in progress Wait...”
and at the end the message “Test executed correctly.”.
Note : if you select the item “ALL” or the item "T-­DATA Giga"
the display shows the message “Insert the T-­DATA Giga.
Press OK to confirm or ESC to cancel.”. Press
OK to execute
the Test.
Note : do not interrupt execution of a Test in progress to avoid
damaging the scale.
ADC
The Test verifies operation of the A/D converter of the load cells
and the power supply reading.
Press
ESC to exit the Test.
Note : the display of unstable values indicates A/D converter
malfunctioning.
Digital Outputs
The Test verifies operation of the Alarm Out, of the outputs of the
“7-­Power Outputs", “Relay Output”, “3-­Relay Outputs” and
“4-­Relay Outputs” options, enabling the individual outputs three
times. To conduct the Test, select the Test that you want to
execute, then press
u . Press ESC to exit the Test.
Serial Lines
The Test verifies operation of the L-­Link, CAN-­Bus, COM A and
COM B Ports.
To conduct the Test, select the Port you want to verify, then
press
u
. The display shows the message "Test in progress.
Wait...” and at the end the message “Test executed correctly.”.
Note : to execute the L-­Link or CAN-­Bus Port Test, you must have
connected a CAN device to the connector.
Note : to execute the COM A or COM B Port Test, you must have
connected a RS232C Test Plug to the connector.